SLJ WCB clutch valve drive device

There are 8 models in this series, with speed ratios ranging from 26:1 to 520:1 and torques ranging from 300NM to 22000NM. The torque difference between every two adjacent models is very small, which helps customers save a lot of costs when choosing specific products.  
The separation box is specifically designed to be matched with pneumatic actuators for butterfly valves, ball valves, and plug valves.  
This device can be manually operated during installation and system testing can be performed when the air source is not loaded.  
It can be directly installed on the most popular pneumatic actuators on the market.  

Installation and operation instructions
Connect the bottom of the reducer to the valve and the support surface to the cylinder. Then slide the valve shaft onto the inner hole of the intake cylinder until the end of the valve shaft fits well with the square hole of the cylinder.  
When rotating the lever (180 ° outward) to mesh with the worm, tooth collision may occur. In this case, you need to turn the handwheel to a certain angle so that they can mesh with each other.  
It is not allowed to drive the equipment simultaneously by pneumatic and manual means.
 
 
Product characteristics
● Cast steel casing
● Fully stamped handwheel (200-350)
● IP65 protection level
● Nickel plated input shaft for better corrosion resistance
● Ductile iron worm gear
● NBR sealing material
● Suitable for working conditions between -20 ℃ and 120 ℃
 
customized
Stainless steel or LCB casing
IP68 protection level
Aluminum bronze worm gear
Stainless steel input shaft
Suitable for high temperatures below 320 ℃

Main component materials

Main technical parameters